#Garage_Door_Installation

How to install a Garage door, initial steps

If you want to install the garage door on your own then you have followed these steps:

Step 1

You will want to issue tensions from the torsion speed before you start working on the door. The hinge is adjusted from the clamping spring axis to the start of the hinge, and then the forceps wedge the pliers into the head of the door. Adding a steel rod into those holes of the spring lava cone, including four holes for tightening and tightening. Tightly on the pole, loosen the set of twisted cones. Using steel loosening in spring quarter flip. Alternately use the two joysticks to stabilize the cone and prevent it from rotating after the first stick.

Step 2

Starting from the top panel and eliminating the hinge of the panel. Please work carefully when you use the glass. Disconnect or remove it in the door frame to disconnect the trajectory. If you intend to replace the automatic door turning device, the Opener`s Trail will be eliminated from the OPER. Eliminate elderly automatic garage door turning devices.

Step 3

Start with the top panel and remove the hinges that connect to the bottom panel. Loosen or loosen the bolts on the door frame to disconnect. If you plan to replace the automatic door opener, remove the traces of the door opener from the beginning and cancel the door opener.

Step 4

If you have a dual-garage door installed, the reinforcing lever is placed on the top panel to keep the door to bend in the middle. Determine the column. Drill a borehole, secure the bar with screws. The hinge is twisted on the peak of each panel. Many new doors reach a pilot hole drilled from the producer. Set the bottom plate in the door opening. Keep the panel vertical by driving a nail into the wall near the board and then bending it to hold the panel in place. Make sure it is flat before installing another panel.

Install the garage door

After the above steps, you can now install your garage door panel, so let you start. If you want to install the mirror garage door, place the reinforcing rod on the top plate to make the door away from the middle. Determine the column. Drill a borehole, secure the bar with screws. The hinge is twisted on the peak of each panel. Many new doors reach a pilot hole drilled from the producer. The torsion shaft supports the base of the bottom plate and the peak of the highest panel. Set the substrate to the door opening. Hold the panel vertical by driving the nail to the wall near the plate, then bending it to fix the panel into place. Before attaching another panel, make sure it is flat.